Stainless steel stud bolts, stainless steel U-bolts, stainless steel bolts custom


Company Name: Dongtai Huayite Steel Products Factory

Phone: 0515-85926750

Mobile: 15851034545, 13805110750


Fax: 0515-85520750

Address: No. 1, Kaizhuang Industrial Park, Dongtai City, Jiangsu Province


Precautions and solutions to prevent the locking of stainless steel standard parts

Your current location: Home >> News >> Industry news

Precautions and solutions to prevent the locking of stainless steel standard parts

Release date:2018-11-05 Author: Click:

Precautions and solutions to prevent the locking of stainless steel standard parts

1. When using stainless steel, do you always lock the nut at a fixed speed?

If you are a first-time user or a user who is not familiar with the stainless steel process, you should consult your supplier about the characteristics of stainless steel. In general, slowing down the lock can greatly reduce (or even completely avoid) the chance of locking. Because heat often occurs when it is locked, when the heat energy increases, the probability of locking increases. When in use, the speed of locking the stainless steel fasteners should be lower than the speed of locking the carbon steel.

2. Is the screw or nut lubricated before locking? If the answer is “No”, it is recommended to use butter, molybdenum disulfide, graphite, mica or talc to lubricate the inner and outer teeth to reduce the lock. Coating is also an effective way to lubricate. The nut that is buckled will have a layer of lubricating film between the nut and the screw.

3. Are you using the same grade of screws and nuts?

If the answer is yes, it is recommended to use different grades of screws and nuts, such as 304 with 316 and so on. However, it should be noted that the grade of stainless steel selected should also meet the requirements of its own rust and corrosion resistance.

In addition, the most common case of locking when locking the flange. Suppose you have noticed and followed the above points, including the use of washers, sealing nuts (it is also recommended to use longer nuts, such as GB6170 or DIN934), diagonally on the nut, slowly rotate to the appropriate tightness Degree, etc., if it still can't be solved, it can't be unloaded after pre-locking. Finally, you have to temporarily use carbon steel nut when pre-locking the flange device, and then use the stainless steel screw when you finally lock it. Cap, find a balance between beautiful rust and no lock.

Stainless steel standard parts are prone to lock-up and lock-up, so we must first find out the cause of the lock-up phenomenon. Then, the targeted analysis and processing of the cause of the lock is carried out, and the solution is selected to solve the locking problem of the stainless steel standard parts at a reasonable and correct speed.

Stainless steel standard parts

  • Service
  • Tel
  • Mess
  • Web
  • Advisory